Daily maintenance of spunbond non-woven machinery

Release time:

2021-11-01

What is more important about mechanical equipment? In addition to the correct way to operate at the time of use, it is also very important to complete the follow-up maintenance. However, there are often many users who do not pay attention to the maintenance of mechanical equipment, which leads to mechanical equipment. After the equipment has been used for a period of time, it often has problems or has a short service life. Different equipment has different protection methods. Next, the spunbond non-woven machine manufacturer will introduce us to the daily protection of the spunbond non-woven machine. The spunbond non-woven machine can not allow excessive moisture and oil to enter the pressure system. In order to prevent malfunctions, shorten the service life of the cylinder tube, ensure the air is dry and clean, if possible, check that the amount of oil in each inner cup of the converter is sufficient When the pressure relief valve is not used for a long time at the back end, it should be pushed forward. When the operation is stopped, the power switch should be turned off. The compressed air control valve, the shaft and each part should prevent magnetic loss. Install the side sliding seat parts of the workbench and the precision and high complexity. They are often wiped clean and oiled for maintenance to prevent the accuracy of rust from being affected. Pay attention to the protection of the environment and machinery. The workshop environment must be clean. It must be cleaned before operation. The voltage and power should be tested. Ensure that the voltage is used to prevent the voltage from being too high or too low. Do not use it to be contaminated or touch it with your hands.

The spunbond non-woven machine can not allow excessive moisture and oil to enter the pressure system. In order to prevent malfunctions, shorten the service life of the cylinder tube, ensure the air is dry and clean, if possible, check that the amount of oil in each inner cup of the converter is sufficient When the pressure relief valve is not used for a long time at the back end, it should be pushed forward. When the operation is stopped, the power switch should be turned off. The compressed air control valve, the shaft and each part should prevent magnetic loss. Install the side sliding seat parts of the workbench and the precision and high complexity. They are often wiped clean and oiled for maintenance to prevent the accuracy of rust from being affected. Pay attention to the protection of the environment and machinery. The workshop environment must be clean. It must be cleaned before operation. The voltage and power should be tested. Ensure that the voltage is used to prevent the voltage from being too high or too low. Do not use it to be contaminated or touch it with your hands.